Monday, September 5, 2011

Igarashi 18X33mm flat can motor for a Bachmann U33B...


...hardly an Athearn but, maybe there was something to gain.

Photobucket

Photobucket

The new motor came from an online vendor. Since dual shaft motors can be expensive, I had to take a chance when I found these for around $7.50 each, including shipping. They were a drop in fit for the Bachmann and AHM all wheel drive diesel models, but the shaft is too small for an Athearn...a good thing as I found later.

The only modification required for the Bachmann was a simple bend on each of the posts to clear the frame. Once the leads were soldered on, it was a simple matter to place a small blob of silicone adhesive caulk to the frame, nestle the motor into place...making sure all remains properly aligned while setting.

Photobucket

You can see in this side-by-side that the motor truly is a drop in fit, being about 10% heftier in the field magnet and case but well within tolerances for clearing the body shell...

Photobucket

An honest evaluation would include increased pulling power, it is a beast compared to its former self. It also runs much slower at the top end of the throttle, both great qualities that I figure comes from the new motor's beefier measurements over a stock buzzer.

Sadly, it does not have very good slow running qualities, not even for a road unit, dashing any hopes of mass re-motorings of the fleet on a budget. The original motor runs much quieter and has better low end throttle control---unless it's burnt out like this one was, of course. Because the new motor is also a good bit louder, that leaves it relegated to the holiday tree lapping fleet for the most part...a good thing since these locomotives tend to chew through motors about ever three years under those conditions anyway.

In the end, it's not bad for seven bucks, just save you peanuts up for one of the better can motors when you want a whisper quiet tie crawler. However, this one is more than worth it for rescuing the family Christmas gear grinder, and will last for many holidays into the future.

6 comments:

COLDSHIVER said...

hi nice review with pics.
i too just found these motors on ebay for the same price but yet to order. i want to use these in my scratch building project, starting from separately bot trucks and all that!

can you tell me how was the motors pulling performance? say 5-6 hoppers on a level grade?

and when you mention sound is it really a shrieking like in so many cheap Chinese toys or just a small squeal ?
thanks ur help is much appreciated

Br'er Shaygetz said...

It's not shrieking so much as it's gear noise, a good bit louder than stock.

The pulling is great, much better than stock, it just doesn't have the low end performance needed for a switcher. I'm going to try a resistor wired into the circuit to see if that helps.

Blessings, BC

COLDSHIVER said...

thanks, appreciate it, maybe i'll order a few after all, with 7 bucks a piece one can't go wrong much!

Donnell Wells said...

Hello Bob,

I think you have given me enough information to warrant ordering a few and testing them out myself.

I will probably be adding flywheels to see if they affect the low-end speed performance. i try and remember to let you know what I find.

Thanks Again,
Donnell

Br'er Shaygetz said...

You're quite welcome...any updates would be appreciated. Many thanks...

Donnell Wells said...

Hello Bob,

I ended up purchasing 15 of these motors. I think they sound fine and even though they have a lower top end no-load speed then say a Buehler, Mashima, or Kato HM-5 motor I think they'll do just fine!

I'm actually having 30 custom hex flywheels made specifically for these motors which should arrive in a little less than two weeks from today. So, again, I'll let you know how everything goes!

Thanks again for the review, and I do like the rest of the site.

Sincerely,
Donnell